steelworker or welder to build stand?

[monkiboy]

does anyone know a reputable steelworker or a welder? i'm looking for someone to build me a stand for my 210g build. i could provide material if required but i want a quality job done and if possible at an affordable rate...

 

thanks for any help or referrals you can provide!

[AlanM]

I'd been doing searches on the same subject recently both here and on CMAS forums and a few folks recommended these guys, which are right up the road from you (and me).

 

http://www.rockvillesteelco.com/index.html

[matt]

Yauger found someone who did a good job, not sure how far from MD...but his stand is nice

[monkiboy]

thanks for the information, folks. i've heard back from tony already with a quote and will check out the place alan suggested as well for comparison. i've actually used the latter before for my entrance gate and they were great and affordable.

[AlanM]

Right. Tony is the guy from CMAS, right? I've read good stuff about his stands. Tempted to do that instead of a 3/4" plywood box for mine too.

[Big Country]

Right. Tony is the guy from CMAS, right? I've read good stuff about his stands. Tempted to do that instead of a 3/4" plywood box for mine too.

 

Yes, Tony is from CMAS. His screename on CMAS is Tony, he lives on the lower side of Baltimore in Halethorpe, MD

[DCReefer1964]

Yup Tony is the man.

[dave w]

I have a friend who also has been a welder for 10 years. He works by the day and I'd hope he would be cheaper than a company. I'll PM you his phone number, I think he lives in DC now.

[monkiboy]

I have a friend who also has been a welder for 10 years. He works by the day and I'd hope he would be cheaper than a company. I'll PM you his phone number, I think he lives in DC now.

 

great, i got your PM. i'll give him a ring!