watson_barrett September 18, 2009 Share September 18, 2009 I would like to have two acrylic stands made to put my skimmer and Ca reactor on in my sump. Anyone have any suggestions on who to contact to perform work? I think NAGA did a demonstration at the last meeting I was at... Idealy both would be shaped like an upside down U or i guess a lower case n : ) Link to comment Share on other sites More sharing options...
zygote2k September 18, 2009 Share September 18, 2009 I can bend 1/4" for you. Link to comment Share on other sites More sharing options...
jason the filter freak September 18, 2009 Share September 18, 2009 how big of stands do you need, i've done extensive work with acrylic up to 1/3" and with a heat gun a small array of tools it's a cinch Link to comment Share on other sites More sharing options...
lanman September 19, 2009 Share September 19, 2009 INSPECTOR on WAMAS does acrylic sumps, tanks, etc. bob Link to comment Share on other sites More sharing options...
luceneck September 19, 2009 Share September 19, 2009 (edited) I have no idea if this makes any differences or not, but if you use an acrylic stand which has a flat face, won't it change the flow in your sump? You may be better off using an eggcrate stand because the slots will allow the water to flow through it. Keep in mind this is just food for thought and not a warning. Good luck Edited September 19, 2009 by luceneck Link to comment Share on other sites More sharing options...
watson_barrett September 19, 2009 Author Share September 19, 2009 I have no idea if this makes any differences or not, but if you use an acrylic stand which has a flat face, won't it change the flow in your sump? You may be better off using an eggcrate stand because the slots will allow the water to flow through it. Keep in mind this is just food for thought and not a warning. Good luck That's why it will be n shapped, it will be only 3 sided not 5 to allow flow, tried egg...TRASH!!!!!!!!!!!!!!! Link to comment Share on other sites More sharing options...
Coral Hind September 19, 2009 Share September 19, 2009 How wide and how tall do you want it? Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now