GOSKN5 May 17, 2022 Share May 17, 2022 I purchased a used Apex Classic with the controller. I have figured out how to program lights, heaters, etc. I need some help with the Avast ATO. It is wired into a breakout box and float switch. I plugged the breakout box into the I/O port on the Aqua Controller. I cannot figure out how to program the ATO using the Apex controller display. I read online something about SW1 etc.. but I don’t see that as an option in the programming. Any help would be appreciated! Thanks! Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
cpu933k May 17, 2022 Share May 17, 2022 I don't think you can program it though the Controller. You need to do it through Apex Fusion. On the Outlet the pump is plugged into, you need to change it to advanced control type and then use code similar to: Fallback OFF Set OFF If SW1 CLOSED Then ON Link to comment Share on other sites More sharing options...
GOSKN5 May 17, 2022 Author Share May 17, 2022 Dangit, I don’t have Fusion or even internet at this time. No other workaround? Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
lynn.reef.nerd May 17, 2022 Share May 17, 2022 Can you make your phone into a hotspot and go that route? Link to comment Share on other sites More sharing options...
WheresTheReef May 17, 2022 Share May 17, 2022 (edited) 59 minutes ago, GOSKN5 said: Dangit, I don’t have Fusion or even internet at this time. No other workaround? Sent from my iPhone using Tapatalk You should be able to connect a computer/laptop directly to the controller using the Ethernet port. You need to modify your network settings to do so. Below are instructions someone posted to update the firmware. Just follow the network setting instructions in the link. You will need to undo your changes when you’re done. Once you establish connectivity between your pc and apex, you should be able to enter the apex’s local IP address into a browser to access the controller’s local web interface. https://support.neptunesystems.com/support/solutions/articles/3000017576-how-to-access-your-classic-dashboard-pc https://forum.neptunesystems.com/showthread.php?3080-Connect-PC-Mac-directly-to-controller-to-update-firmware Edited May 17, 2022 by WheresTheReef Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now