ORP (Oxygen Reduction Potential)

[Guest tgallo]

can anyone with a orp monitor post there readings, with or without a ozone reactor ,if without pls specify.

[kngfisher]

can anyone with a orp monitor post there readings, with or without a ozone reactor ,if without pls specify.

 

 

287 w/o ozone - Milwaukee SMS125 pH/ORP Controller

[johnnybv]

can anyone with a orp monitor post there readings, with or without a ozone reactor ,if without pls specify.

Oxidation reduction potential (ORP)

I run 350 - 430 with ozone at the shop in my coral system

at home about 300 - 350 with just a deltec 701

[Guest tgallo]

Oxidation reduction potential (ORP)

I run 350 - 430 with ozone at the shop in my coral system

at home about 300 - 350 with just a deltec 701

 

 

John, how many MG unit are you using and are you feeding thru the skimmer.

[johnnybv]

John, how many MG unit are you using and are you feeding thru the skimmer.

I run a 200 mg unit through the deltec 701 with a tee allowing the skimmer to pull fresh air as well. The skimmer needed to pull more than what it could get through the ozone unit, hence the Tee and additional checkvalve to prevent O3 from escaping.

[Guest HVF21221]

300mv with a 200mg Red Sea Ozonizer. This is on a 340gal. system. When the system was new I would hit my setpoint of 400mv all the time. Now I'm lucky to hit 330mv.

[emissary]

http://reef.korff.org/statistics.html

 

flat areas are "lights out" periods. No ozone reactor.

[Guest tgallo]

300mv with a 200mg Red Sea Ozonizer. This is on a 340gal. system. When the system was new I would hit my setpoint of 400mv all the time. Now I'm lucky to hit 330mv.

 

thats intresting, i'm guessing your bio-load has increased since you set the tank up.

 

I'm steady at 400mv, 300 gallon system and dosing about 25mg thru my skimmer, my system has only been up and running for 3 months now, with a heavy bio-load.