Help with Noopsyche k7v3 (II) lights

[YHSublime]

Hello! I have x3 k7v3 (II's I believe) the kind that connect via a USB controller.

 

x2 of them are functioning fine, but the third one started blinking, meaning, all the LED's in the unit turn on and off every five seconds or so. I unplugged the unit last night, and then plugged it in again this morning. Everything worked as usual momentarily, and then it began to flash again after about a minute of being connected to power again.

 

I have tried to factory reset the unit by holding down both the buttons on it for 10 seconds, but it doesn't work. I have tried to connect it to the controller (USB) but that doesn't work either.

 

The light on the unit is flashing blue, I am at a loss on what to do!

[ReeferMan]

Did you try another power supply?

[YHSublime]

2 hours ago, ReeferMan said:

Did you try another power supply?

i did not, will check in the AM

[ReeferMan]

Normally its the power supply 

[YHSublime]

1 hour ago, ReeferMan said:

Normally its the power supply 

you nailed it! Should be interesting getting another one.

[ReeferMan]

Glad it worked

[AlanM]

depending on the voltage and current output I might have a meanwell from a DIY build here that could work in a pinch.  What's it say on the power supply brick?

[YHSublime]

15 hours ago, AlanM said:

depending on the voltage and current output I might have a meanwell from a DIY build here that could work in a pinch.  What's it say on the power supply brick?

 

I did a little digging around, and for $20 I found a power brick recommendation on Amazon, to the door in 24 hours, so now I'm back on schedule. 

 

Now the controller (that I've only used maybe 3 times total) has crapped out. I have no idea how to adjust these lights outside of the controller (and barely with it)

I was hoping to ride these lights for at least a few more years without any problems.