Jump to content

Recommended Posts

I just recently acquired a K2R reactor, and I was wondering if anyone else had one.

I can't decide what kind of feed pump to use.

Any suggestions?

I just recently acquired a K2R reactor, and I was wondering if anyone else had one.

I can't decide what kind of feed pump to use.

Any suggestions?

 

Mj 900 or 1200....smaller if theres less height or less output.

 

Sean

You can also T off the feed (typically you don't need to much feed going into your calcium reactor) and send it back into the sump.

 

Dave

Guest snapper

I just use a little rio powerhead. I use one of those john guest slip unions from lowes to hook the tube to the pump output.

 

if the reactor is not in the sump, i recommend against using a "T" off of the main pump because it WILL over pressurize it and it WILL leak,

 

also, if it sits in the sump, it's possible that the recirc pump can pull enough to make the effluent drip all on it's own.

Thanks for the replies guys.

I think I'll go with the MiniJet 404. It's has a low output that is adjustable too.

Guest snapper

Thanks for the replies guys.

I think I'll go with the MiniJet 404. It's has a low output that is adjustable too.

 

That should work nicely. Try this, after you get it set up and the whole thing primed and a drip rate going, try discinnecting the miniJet and see if it will continue to work. Mine does. Everything has to be level in the sump for this to work. ...just saves on a little electricity.

Create an account or sign in to comment

You need to be a member in order to leave a comment

Create an account

Sign up for a new account in our community. It's easy!

Register a new account

Sign in

Already have an account? Sign in here.

Sign In Now
×
×
  • Create New...