Icecap 4K issues

[discretekarma]

Hi! I had two of the newer icecap 4K pumps hooked up to a Wi-Fi controller and running for about a week. Today I added another pump and a Wi-Fi controller. 
 

I set all three to 100% since the tank is cycling and I wanted to clear off the bare bottom of the tank. 
 

After a few seconds I noticed the pumps were no longer running. I can no longer connect to any of them from the app and the leds on the controller cycle through red blue green white like they usually do and then I get a quick green status light, yellow mode light and then it starts it’s boot loop over. 
 

They’re connected to a dedicated 20a gfci breaker that currently only has two viparspectra 165w, a curve 9+ dc skimmer, and a cor20 return pump, and a 500w titanium heater. 
 

I can’t seem to find any info online about it and no phone number for coralvue. I’ll try to email them but wanted to see if anyone knows. 
 

Just to reiterate, two pumps and a controller are a week old and one pump and controller arrived today.

[discretekarma]

Quick update. My wife reset each of them over and over and eventually the boot loop stopped and they work fine now.