Help Needed: Plumbing Question

[pnchowdary]

I am trying to setup a water mixing station with 200 gal plastic tanks. I am hoping to tap directly into the cold water supply line for my water heater and branch it the Rodi supply line. I am trying to figure out what connectors would enable me to go from a 0.5 inch cpvc pipe to a standard rodi tube.

 

I was able to find shark bite connectors that go from 0.5 inch cpvc to 1/2 or 3/8 compression fittings, but unfortunately i could find any connectors to go from this to the standard Rodi tube.

 

I am stuck here for a long time and would greatly appreciate any help that you could offer me in this regard.

[Jeremy]

Did you see this?

 

https://www.reef2reef.com/threads/hooking-up-rodi-directly-to-water-line.747364/

Edited March 30, 2024 by Jeremy

[pnchowdary]

Did you see this?
 
https://www.reef2reef.com/threads/hooking-up-rodi-directly-to-water-line.747364/

Thank you very much @Jeremy. This is exactly what I was looking for. I will take a look at it. Appreciate your help.


Sent from my iPhone using Tapatalk