Zaphodent May 19, 2019 Share May 19, 2019 Just got a avast kalk stirrer but it’s back siphoning into the ato reservoir. Installed a check valve but it’s creates too much resistance for ato to pump into the kalk stirrer. Anyone have this issue with a kalk stirrer? Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
hlem May 19, 2019 Share May 19, 2019 Install a T connector. ATO to T. One end of T goes to reactor. The other end points up, of course add some tubing to that end and hang up high above the reactor. I do that with the output side of the reactor as well. Link to comment Share on other sites More sharing options...
Zaphodent May 19, 2019 Author Share May 19, 2019 Install a T connector. ATO to T. One end of T goes to reactor. The other end points up, of course add some tubing to that end and hang up high above the reactor. I do that with the output side of the reactor as well. So one end for the ato, the other end goes the reactor. Sorry, kind of don’t get where the tubing for the third one will go? Your saying to hang the T junction high above the reactor?Thanks Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
hlem May 19, 2019 Share May 19, 2019 12 minutes ago, Zaphodent said: So one end for the ato, the other end goes the reactor. Sorry, kind of don’t get where the tubing for the third one will go? Your saying to hang the T junction high above the reactor? Thanks Sent from my iPhone using Tapatalk Yes the tubing coming out of the T should be the highest point. So when the pump stop, it will suck air instead of water from the reactor. Link to comment Share on other sites More sharing options...
Zaphodent May 19, 2019 Author Share May 19, 2019 Yes the tubing coming out of the T should be the highest point. So when the pump stop, it will suck air instead of water from the reactor. Awesome, can’t wait to try that, just found a old thread on this after some digging Sent from my iPhone using Tapatalk Link to comment Share on other sites More sharing options...
hlem May 19, 2019 Share May 19, 2019 Yup. Was about to send you that post. But make sure the pump isn’t strong enough to pump water all the way up and out of the tube. Link to comment Share on other sites More sharing options...
bbyatv May 19, 2019 Share May 19, 2019 I would avoid setting up a Kalk stirrer on your ATO at all cost. This is a very risky practice. Talk with the countless aquarists who have lost all their corals. There are better ways to do this. I would encourage you to read this article. Before you start I would read the entire article. https://reefs.com/magazine/the-kalk-calc-combo-method-185.html/ Good Luck, Bruce Link to comment Share on other sites More sharing options...
Recommended Posts
Create an account or sign in to comment
You need to be a member in order to leave a comment
Create an account
Sign up for a new account in our community. It's easy!
Register a new accountSign in
Already have an account? Sign in here.
Sign In Now